music with stepper motors
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
 
 
 

1.2 KiB

MidiStepper

Made for an old (AnyCubic) Trigorilla-Board from an 3D-Printer. Also compatible with Arduino Nano and old floppy drives.

Floppy pins:

      .....j..DS.......
..G5  . ...j..GG.......

j: jumper (drive select)
D: direction
S: step
G: corresponding ground
5: 5V for the motors

Caveats:

The ATmega2560 has 6 timers, so we can use them to generate the square waves for the steps. Be aware that delay() and similar arduino-functions will not work as expected if you extend this and use Timer0. RAMPS14-compatible boards have only 5 stepper drivers, so we're fine. Other arduinos don't have enough timer peripherals, so we generate them in software. This could be done in an ISR. See: https://www.youtube.com/watch?v=fHAO7SW-SZI

Usage:

The arduino part accepts raw midi messages over its serial interface. baudrate is 115200. Use the python script send.py to send midi files over the serial port. It can also act as a virtual midi port.

Compile:

$ git clone
$ virtualenv -p python --no-site-packages .
$ source bin/activate
$ pip install -U platformio
$ pio run
$ pio run -t upload